Evolution Powersports

Can-Am Maverick R P48 Turbo System With MG1 ECU Unlock & Flex Fuel Rising Rate CodeShooter Power Flash

After relentless development and with testing finally complete, EVP is ready to raise the roof higher with the all-new Paragon P48 Turbo System for Can-Am Maverick R and Maverick R MAX models.
Evolution Powersports wanted to bring to the Maverick R community a clean sheet, no compromise, direct replacement turbocharger to serve as a base for all our big power packages. Because the OEM Maverick R turbocharger is 100% custom to the vehicle and mounts to the block, making a direct replacement turbocharger required some serious engineering challenges. There are 3 main components to any turbo – Exhaust Housing, CHRA and Compressor Housing. All three needed to be 100% engineered specifically for the Maverick R due to its unique mounting system and electronic wastegate actuator.
The whole point of making a direct replacement turbo is so all the factory mounting system can be utilized, and all exhaust and intake and charge tubes are in the OEM location. The reasons why these are important factors are they eliminate major durability issues and cracking components associated with most other aftermarket turbo systems. In addition, by locating the intake, compressor outlet and exhaust housing in the identical locations as stock, the OEM intake, exhaust and charge tube or previously purchased components fit seamlessly so they do not have to be purchased again.
The turbocharger CHRA is a ceramic ball bearing designed to spool instantly while being durable at high boost pressures. We build both the compressor and exhaust housing to accept a wide variety of compressor and turbine wheels so there is a ton of flexibility in the design. The P48 has a 48mm inducer on the compressor, .55 A/R and 47mm exducer on the turbine/hot side. These geometries provide great spool and the ability to make over 500 crank horsepower. The P48 on a bone stock Maverick R engine makes 367 WHP (411 crank) on E85. This is approximately 145 WHP over a stock Maverick R.
All Maverick R MAX P48 Turbo Systems will include our advanced DCT+ transmission tuning with Launch Control. The tunes available initially will be 91, 109 and E85, with Flex-Fuel tuning also available. Lastly, every Paragon turbocharger is serialized and carries an industry exclusive 6-month limited warranty.
P48-415 TURBO SYSTEM INCLUDES:
• Paragon P48 Turbocharger
• ECU Unlock & Hard Case
• P48-415 Power Flash With Launch Control & Transmission Tuning
•
Flex Fuel Assembly with Flex Fuel Sensor
• EVP Charge Tube Kit (Black)
• EVP BOV Kit
• EVP HFI Kit
• EVP Catch Can Kit
• EVP Plenum Clamp Assembly
• Injectors, Set of 3
• 4 Bar Map Sensor Kit
• Fuel Pump Assembly with 340 LPH Pump
• OEM Turbo Gasket
• Big Turbo Spark Plugs, Set of 3
WHY FLEX FUEL?
A first-of-its-kind, plug-and-play factory ECU implementation of Flex Fuel for the Can-Am Maverick R.
Why do you NEED an EVP Flex Fuel system? Much more power can be achieved on Ethanol fuels vs pump gas or even higher-octane race fuels because of the combination of increased knock resistance and the property of alcohol fuels to remove heat from the charge air going into the engine. Although this is a simplistic explanation, the fact is that Ethanol-blended fuels allow us to run much more boost and optimize ignition providing a much higher-performing and safer tune.
Prior to EVP Flex Fuel , the two largest issues customers had to deal with were either buy E85 by the barrel from a reputable fuel supplier, which is expensive and a hassle to transport, or run around town w

Вказано ціну виробника (рекомендована роздрібна ціна в USD). Ми — дилер: підтвердимо актуальну ціну, наявність і строк поставки під час замовлення.

Виробник	Evolution Powersports
Техніка	SxS (UTV)
Сумісність	Can Am
Моделі	Maverick R, Maverick R MAX, Maverick R X RC
Роки випуску	2024–2026